SeaLand 3100 Specifiche

Bulletin P-3100DWYER INSTRUMENTS, INC.Phone: 219/879-8000 www.dwyer-inst.comP.O. BOX 373 • MICHIGAN CITY, INDIANA 46360, U.S.A. Fax: 219/872-9057 e-ma

Page 9• CHANGE UPPER RANGE VALUE1. Access the menu by pressing the Zero+Span buttons.2. Move to the next menu by pressing the Zero button until the 1

Page 10Chapter 4 Installation4.1 OverviewThe information in Chapter 4 explains installation.4.2 Safety Messages Procedures and instructions in thi

Page 114.6.1 Power SupplyThe 3100 Pressure Transmitter requires an 11.9 – 45 VDC power supply. A 250 ~ 550Ω (24 VDC) loop resistance is recommended fo

Page 12B.Wiring InstallationGeneral-use (Figure 4-4a)1. Use metallic conduit or waterproof cable glands for wiring.a. Apply non-hardening sealant to t

Page 134.8 Mechanical ConsiderationsFigure 4-6 is a dimensional drawing for the 3100. Figure 4-7 showshow the A-630 angle bracket is mounted to a pipe

Page 145.4.1 Process VariableThere are two process variables in the 3100 Smart Pressure Transmitter. The primary variable and temperature compensated

Page 155.9 CalibrationThe scale is implemented by calibrating the transmitter. Trim functionhas several calibration functions. Smart transmitters

Page 166.3 Hardware DiagnosticsIf there is a failure despite a diagnostic message on the HHT, Table6.1 can help troubleshoot the problem. 6.4 Hardware

6.4.2 Disassembling the Housing The transmitter is designed with dual-compartment housing; onecontains the electronics module, and the ot

Page 18Appendix I3100 SMART PRESSURE TRANSMITTER - LCD DISPLAY CODEMessageADJ-UADJ-LZEROSPANBT-ERRP-LOCKZT-ERR-TR-ZR-ERRSP-ERR-ZR--SP--ZA--DONE-RNGOVR

Table of ContentsChapter 1. Introduction1.1 Using This Manual1.2 Overview of Transmitter1.3 Software CompatibilityChapter 2. Handling Cautions2.1 Unpa

©Copyright 2014 Dwyer Instruments, Inc. Printed in U.S.A. 5/14 FR# R6-443807-00 Rev. 6DWYER INSTRUMENTS, INC.Phone: 219/879-8000 www.dwyer-inst.comP.O

Chapter 1 IntroductionThe 3100 Smart Pressure Transmitter is calibrated at the factorybefore shipping. To ensure correct and efficient

1.2 Overview of TransmitterThe Mercoid®Smart Pressure Transmitter is a microprocessorbased pressure transmitter with a capacitance sensor optim

Page 4Chapter 2 Handling CautionsThis chapter consists of cautions for transmitter handling, storage,installation, insulation and explosion structur

Page 52.1 Unpacking TransmittersWhen moving the transmitter to the installation site, keep it in theoriginal packaging. Unpack the transmitte

Page 64. After completing the test and being very careful not to touch exposed conductors. Disconnect the insulation tester and connect a 100kW resist

Page 7Fail Safe mode can be set via Jumper switches provided on the LCDmodule or the main CPU module. The jumper switch for anindicating trans

Page 83.7 Configuration of Zero and Span ProceduresThe ZERO and SPAN Buttons are under the transmitter’snameplate. The ZERO, SPAN, ZERO T